Hello,
I am thinking to use on my c20xe engine the x22xe engine block.
Does anybody knows what is the length of the connecting rod on these engine?
I must know because I want to see if the rod/stroke is good for 8000rpm reving.
Also I will make custom steel rods for this aplication.
So does anybody measured a x22xe con rod?
Some say that is 148mm.
But I found in a url that pauter was made a steel con rod of 159,5mm length for 2.2 calibra turbo use.
http://www.flatlander-ipp.co.uk/pauter/ ... opel.shtml
2.2L 16V Calibra, Vectra Turbo connecting rods 6.280" (inches) = 159,5mm
So is this the correct length for the x22xe connecting rods?
If yes the rod/stroke is even better than the c20xe engine itself!
rod/stroke c20xe 143mm / 86mm = 1,662
rod/stroke c22xe 159,5mm / 94,6mm = 1,685
Thanks,
Alex
x22xe con rods for c22xe/c23xe project
This forum is for English language discussion about Opels, Opel Club Finland and related issues
Hyppää
- Opel Club Finland
- ↳ Uutiset ja tiedotteet
- ↳ Jäsentiedotteet
- ↳ Jäsen materiaali
- ↳ Tapahtumat ja OCF-keskustelu
- ↳ OCF alueet
- ↳ Ladies Only
- ↳ Yhteistyökumppaneiden tiedotteet
- ↳ Rompetori OCF Summerpartyilla
- Opel - tekniikka
- ↳ Opel-keskustelu
- ↳ Bongaukset
- ↳ Opel-gallupit
- ↳ Moottorit ja voimansiirto
- ↳ Diesel
- ↳ Virittäminen
- ↳ Ahdetut moottorit
- ↳ Vapaasti hengittävät moottorit
- ↳ Tekniikan vaihdot
- ↳ Voimansiirto
- ↳ Moottorinohjaimet, lastut ja ohjelmointi
- ↳ Diesel moottorit
- ↳ Kori ja sisusta
- ↳ Autohifi
- ↳ Ilmastointi ja lämmitys
- ↳ Alusta
- ↳ Projektit ja esittelyt
- ↳ Jäsenten Opel projektit
- ↳ Jäsenten muut projektit
- ↳ Pienoismallit ja keräilyesineet
- ↳ Vinkit ja Vihjeet
- Yleistä
- ↳ Yleinen keskustelu
- ↳ Moottoriurheilu
- ↳ Vitsejä, juttuja ja netistä löydettyä
- ↳ English
- Rompetori
- ↳ Rompetori
- ↳ Kerro hyvästä ja huonosta kaupantekokumppanista
- ↳ Yhteistyökumppaneiden tiedotteet
- ↳ Myydään autoja
- ↳ Myydään osia ym.
- ↳ Myydään autohifiä
- ↳ Myydään renkaita ja vanteita
- ↳ Ostetaan
- Extra
- ↳ Testit
- ↳ Nettisivupalaute